RA200 100 Watt Power Amplifier

Rolls » Power Amplifiers »

The RA200 features two 100 watt RMS - 4 ohm outputs, a bridging switch, MOSFET drivers in a voltage and current gain circuit, one second power-up delay, and LED power output meters. The unit is housed in a painted steel chassis and includes a special high performance transformer, and a fused power line. The MOSFET output stage is fault protected which allows the RA200 to forgive momentary output shorts, and has over-temperature protection. CAUTION: The RA200 is convection cooled. Adequate ventilation room for the heat sink fins on the rear panel must be provided.

RA200 100 Watt Power Amplifier

  • MOSFET drivers in a voltage and current gain circuit.
  • 1 second turn-on delay.
  • LED clip indicators for each channel.
  • Fault protected outputs.

Specifications

  • Power Output, Stereo: 100 Watts RMS/ch. 4 ohms, 70 Watts RMS/ch. 8 ohms
  • Bridged: 200 Watts RMS 8 ohms
  • Input Connectors: 1/4" TRS balanced and RCA
  • Output Connectors: Binding posts
  • Sensitivity: <1 VRMS for full output
  • THD: <.08% (1kHz @ 1 Watt)
  • S/N Ratio: 106 dBU
  • Power Bandwidth: DC - 30 kHz +/- 1dB
  • Damping Factor: > 150
  • Slew Rate: 100 Volts/microSecond
  • Phase Shift: <10 Deg., 20Hz - 20kHz
  • Input Impedance: 10 K ohms Balanced
  • Power: 120 VAC 60Hz 2.5A, 230 VAC 50Hz
  • Size: 19" x 3.5" x 7.5" (48 x 9 x 19 cm)
  • Weight: 12 lbs (5.5 kg)